 |
 |
 |
 |
 |
 |
 |
 |
 |
|
|||||||
| Gear Talk about Apparel, Masks, Packs, Air Systems, and all your other gear here. |
Replacement Mini/Axe case
This is a discussion on Replacement Mini/Axe case within the Gear section, part of the Other Markers and Equipment category; Those of you with v3 Mini's or an Axe that didn't come with a nice carrying case might want to ...
 |
|
|
LinkBack | Thread Tools | Display Modes |
|
#1
September 8th, 2011, 01:31 AM
|
||||
|
||||
Replacement Mini/Axe case
Those of you with v3 Mini's or an Axe that didn't come with a nice carrying case might want to consider this. You would have to replace the foam
where the transmitter cut-out is but it should make a ok/cheap case when finished. Tx case (Yes RC was a passion in a past life)  B. 
|
|
#2
September 8th, 2011, 03:20 PM
|
||||
|
||||
|
Good find and not a bad price either! There is also a chance that you won't need to replace the foam as long as your gear fits.
I did RC as well... I had a Boat from Warehouse Hobbies 
__________________
|
|
#3
September 8th, 2011, 05:55 PM
|
||||
|
||||
|
You know what's funny? I already have one of these.
__________________
 You want advise or suggestions on a barrel? Try them out before you decide to buy. It works 100% of the time and saves EVERYONE money.
|
|
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Linear Mode
|
|
All times are GMT -5. The time now is 12:03 PM.
