Hello everyone, I'm new to Invert OG but I've been on A5OG for about 3 years now with the same user name. I have recently started using my Mini I've had for about a year now.

One thing I haven't been able to come up with is a good way to mount a sling to my Mini so I can pull out my TPX when wanted or just to hold to Mini when I don't want to.

Now awhile ago I saw Kanucks plan for a sling mount that Outlaw was going to make for him. It's been awhile since I've seen anything on it and so I decided to go ahead and design my own. Now There are two pieces to it as I didn't like Kanucks plan to have it all hanging from one point.

Both pieced will be made from aluminum without a finish. I looked into it, the time/cost is to much for a first run production anodizing. You can paint it or whatever you would like.

Here is the rear sling mount:


Here is the side sling mount:

(Don't mind the coloring, its just a quick 3D model that the program I use makes)

The sling mounts are 1" wide, for straps or a clip and have side supports for added strength. Also the front sling mount is ambidextrous. I'm lefty so I'm always thinking of making it work for us southpaw players.As for cost it would probably be around $35-$40 for both parts.


Also this was just my first design, and most likely will change a little before production. I just wanted to share it and see if there was a big enough response to produce these.



So my main question is would you buy this for around $35-$40?

I would say start with a prototype and see how it feels. Then post some pics of it on the Mini being hung by the sling.

__________________

I'd be interested after I saw how it hung as well.

Would like to see a prototype of course but looks promising.

__________________