As the topic reads, i have bought them both....

i know there is a guide from maxoc. but i wondering how u get the best out of this. i want it as silence as possible, but if im going under 160 psi, it starts leaking from the front.

i have tried new o-rings and lubed it.

with the stiffest spring in the kit and the delrin bolt. if im running at 160psi and the dwell @ 7ms, i can't make the gun go higher than 270fps. does i do something wrong?

i have heard that u should remove the back o-ring from the bolt, is that true?

and what do i achive?

put in a lower tension spring... This isn't a tippman, (where the spring determines air flow) try a lower spring and see how it goes.

Try removing the back o-ring as well, im not sure what it achieves, but apparently it makes it work better.

Removing the back o-ring allows the bolt to travel easier (less drag) sometimes you have to be carefull because it does increase the speed the bolt moves forward and lighter springs also increase the speed so you could get to a point where you break fragile paint. Getting the pressure down below 160 psi is really pushing the limits of where the gun will operate reliably, good luck.

__________________
For any retail items visit Boss Paint Products.

Mini and BT factory parts.