ok so my invert mini wont fire. it turns on, the air is fine, but when i pull the trigger nothing. i have a tadao board on my mini but everything else is stock. anyone have any ideas what may be up?

the same thing happened to me once. I had taken apart my gun for fun and when i put it back, one row of the pins that connect the two boards was out of their sockets, so everything was fine but it wouldn't register correctly. So check your pins

__________________
Texoma Paintball

Have you tried a new battery?

With the eyes turned off, does the board register a trigger pull?

Have you recently adjusted the trigger settings?

And welcome to the forum!

__________________

agreed with tigar, i was shooting my friends mini this past weekend and the solenoid clicked with eyes off and no air. once gassed up with paint and eyes on it wouldnt shoot. made sure hopper was on, feed with the rip drive to ensure ball in place, and turned eyes off still no shot. tuned the trigger down a bit and tried it again and she was shooting

the magnet might be too tight up at the top and its not registering a pull, ensure that your getting a green blink from the LED every time you pull the trigger once its gassed up

You may also want to view this thread as it covers many of the issues that can be had with minis.

*The Ultimate How To Fix Your Mini Thread*

__________________

Let's hope the AXE don't have those problems.

__________________

thanks guys took your advice, it works now.

Just for future reference, also check the magnet on your trigger. Sometimes the adhesive that holds it in place will let loose, and the magnet will come off and stick to the other magnet. The causes the Hall Effect Sensor to not read a trigger pull.