My invert mini is 2 weeks old and i broke it in with dry firing, I played all day today with it and it was fine except for a jam with my rotor. It is all v2, I cleaned off all debris/paint and checked the eye, cleaned the eye and checked o-rings and oil. The issue is that it chops/ doesn't let paint in the breach because the bolt extends slightly past where the feeder neck is after every 3 rounds or so leading to the gun not firing with the eye on, with the eye off it will shoot but blows the paintball into the air out of the feedneck/doesnt shoot paint at all down the barrel. I read up on the blow back issues but I didn't see anything about the bolt moving too far forward to not allow it to feed paint. Any ideas guys?

Thanks for reading this and hopefully helping me out!

You should be using Dow33 and not oil. Are you sure the spring is installed the proper way? Try resetting the board to factory settings and see if that helps. Yes, I know you said it was 2 weeks old, but I have seen stranger things and sometimes a board reset resolves the issue.

__________________

I used the oil/grease that came with the gun, and i'll try resetting the board, thanks!

That's grease that came with the marker. Good luck with your board reset. Let us know how you make out.

__________________

Don't over-do it with dryfiring. It doesn't really break in your marker, just puts extra wear on your o-rings and such.

Just play with paint and you'll be fine....not a lot to break in.



Try and see if your spring is backwards. Its a longshot but its a potential. The spring is a one way, on one side if you press it onto the bolt, it will click on, the other side will not. Make sure it clicks.

That may help.

__________________