Howdy folks! Finally got my (used) Mini. It came with a Virtue board installed. However, it is set at 10bps w/eyes on in semi. I need to return the board to the factory 15bps Virtue claims it comes pre-set at. How can I get it back to these base settings, or 15bps semi.
All I'm ever going to need is semi at the places I play and the fields want 15bps or slower. So, 15 eyes on, and uncapped eyes off, would be optimal.

I've looked at the Virtue owners manual online but it seems my board is older or something and the steps dont seem to be working out and the picture looks different than mine. Anyone have a pdf or link to the virtue board manuals?

Thanks a million for your input.

I don't see a link on the virtue manual site for the mini.
Virtue Paintball, LLC - Advanced Electronic Paintball Upgrades
Perhaps you could email them and ask.

On My APE board, a reset to default is achieved by removing the battery and leaving it out so the capacitor runs out of juice. You could try that.

EDIT:

Here

http://www.virtuepb.com/products/manuals/mini-web.pdf

__________________

Thanks, thats it!
Returned board back to base setting and it still shoots slower with eyes on. According to Virtue I have an eyes problem. Which is good. That eliminates an expensive board problem.

Does it shoot fine with the eyes off?

__________________

Yes, it rocks with the eyes off. About 10bps with eyes on, barely.

I guess this is a good excuse to get the Virtue laser eyes.

It does sound like your eyes are bad or dirty. Have you taken them out and inspected them?

__________________

Not yet.

This (eyes) will fix 2 of my 3 problems. The last issue is the gun seems to short stroke like an automag every 50th-70th shot. Like the bolt gets hung up in the wrong spot and then KOOOSHHHHHHHHHH, tap the trigger again and it stops immediately and I can resume firing.

See if that issue isn`t resolved by setting the board back to defaults. Who knows what other settings are programmed that could be causing your issues.

__________________

I had similar problems. Go in to programming mode on your board. Once you programming mode is open, hold the trigger for 10 seconds. You will here an audible beep and if you have the OLED, the screen says FACTORY DEFAULT or something close to that. And that should solve your problems.

Try backing out the screw on the trigger just a turn or two, the top one not the one that shortens your trigger pull. I went crazy trying to fix that issue, new o-rings, poppet and hours of headache later, it was that screw.